§ 13.13.100. Permit required.

A.

Installation permits for the installation of all backflow prevention assemblies required by Willcox Water shall be obtained from Willcox Water prior to installation. A separate permit shall be obtained for each required backflow prevention assembly to be installed. A separate permit shall be required for replacement of a backflow prevention assembly which has been previously installed.

B.

Notification. It shall be the duty of the person doing the work authorized by the permit to notify Willcox Water, orally or in writing, that said work is ready for inspection. Such notification shall be given not less than 24 hours before the work is to be inspected and shall be given only if there is reason to believe that the work done will meet Uniform Plumbing Code and University of Southern California standards, as are referenced in the backflow prevention manual.

C.

Stop Orders. Whenever any work is being done contrary to the provisions of the UPC or this Code, Willcox Water or an authorized representative may order the work stopped by notice in writing served on any persons engaged in the doing or causing such work to be done, and any such person shall forthwith stop such work until authorized by Willcox Water to proceed with the work.

D.

Suspension or Revocation. Willcox Water or any authorized employee may, in writing, suspend or revoke a permit issued under provisions of this Code, whenever the permit is issued in error or on the basis of incorrect information supplied, or in violation of any ordinance or regulation of any provision of the UPC or this Code.

(Ord. NS149, § 1, 1993)